Надо попробовать переучить ключ дилерским сканером TECH2. (Второй ключ кстати где?)
Вот процедура.
Tools Required
Tech 2
Techline terminal with current SPS (Service Programming System) software
-Connect the Tech 2 to the vehicle.
-Select "Request Information" under "Service Programming".
-Disconnect the Tech 2 from the vehicle and connect it to a techline terminal.
-On the techline terminal, select "Theft Module Re-Learn" under "Service Programming".
-Disconnect the Tech 2 from the techline terminal and connect it to the vehicle.
-Turn ON the ignition, with the engine OFF.
-Select "VTD Re-Learn" under "Service Programming".
-Attempt to start the engine, then release the key to ON (vehicle will not start).
-Observe the SECURITY telltale, after approximately 10 minutes the telltale will turn OFF (the vehicle is now ready to relearn the Passlock™ Sensor Data Code and/or password on the next ignition switch transition from OFF to CRANK).
-Turn OFF the ignition, and wait 5 seconds.
-Start the engine (the vehicle has now learned the password).
-With the Tech 2 (scan tool), clear any DTCs.