P0446
http://engine-codes.com/ - рекомендую
Первая ошибка по ЕВАП. Может пробка заливной горловины бака не затянута.
Или клапану в обратке карачун приходит.
А вот вторая и третья ошибка как раз по дросселю.
Важнее даже третья - машина не видит домашнюю позицию дросселя.
Так что я бы оттуда начал. Помыть дроссель, проверить контакты энкодера
P0446 Chevrolet - Evaporative Emission Vent System Performance
Possible causes
- Plugged vapor canister
- Faulty vent solenoid
- Pinched or blocked EVAP hose
- Faulty FTP sensor
What does this mean? What does this mean?
Tech notes
Dirt and dust intrusion into the EVAP canister vent hose assembly, resulting in restricted air flow, may cause this condition.
There is a bulletin for the following models:
1999-2007 Chevrolet Silverado (Classic) Models
2007-2008 Chevrolet Silverado Models
Chevrolet Factory Service Bulletin OBDII Code P0446
What does this mean? What does this mean?
When is the code detected?
The Powertrain Control Module (PCM) sets the P0446 code if the vacuum decay rate is greater than a predetermined value.
Possible symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- Possible a noticeable fuel odor caused by the release of fuel vapors
P0446 Chevrolet Description
The Powertrain Control Module (PCM) monitors the performance of the Evaporative Emission (EVAP) system by applying a predetermined level of vacuum to the EVAP system then monitors the vacuum decay rate.
P2135 Chevrolet - Throttle/Pedal Position Sensor/Switch 'A'/'B' Voltage Correlation
Possible causes
- Faulty electric throttle control actuator (TP sensor 1 and 2)
- Throttle Position Sensor harness is open or shorted
- Throttle Position Sensor circuit poor connection
- Faulty accelerator pedal position sensor
What does this mean? What does this mean?
Tech notes
There is service bulletin from GM for
2008-2009 Chevrolet TrailBlazer
2008-2011 Chevrolet Avalanche, Colorado, Express, Silverado, Suburban, Tahoe
2008-2011 Chevrolet Tahoe Two-Mode Hybrid
2009-2011 Chevrolet Silverado Two-Mode Hybrid
Factory Service bulletin P2135
What does this mean? What does this mean?
Possible symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P2135 Chevrolet Description
The throttle Position (TP) sensors 1 and 2 are potentiometer type sensors each with 3 circuits
P2176 Chevrolet - Minimum Throttle Position Not Learned
Possible causes
- Faulty Throttle Actuator Control (TAC) module
- Throttle Actuator Control (TAC) module harness is open or shorted
- Throttle Actuator Control (TAC) module circuit poor electrical connection
- Throttle plate sticking due to carbon build-up
- Engine Control Module
What does this mean? What does this mean?
When is the code detected?
The P2176 code is set whe the difference between the predicted and the actual throttle position is more than a calibrated amount for more than 1.5 seconds.
Possible symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- No throttle pedal response
P2176 Chevrolet Description
The Engine Control Module (ECM) is the control center for the Throttle Actuator Control (TAC) system. The ECM determines the drivers intent and then calculates the appropriate throttle response. The ECM achieves throttle positioning by providing a pulse width modulated voltage to the TAC motor. The TAC system uses the following circuits for Motor control 1 and Motor control 2.
Two processors are also used to monitor the TAC system data. Both processors are located within the ECM. Both processors monitor each other's data to verify that the indicated throttle position is correct.